INDUSTRIAL ELECTROTHERMICS

GALVATHERM IMMERSION HEATERS

General points

Our immersion heaters are manufactured to heat only liquids. They are specially designed with a cable that only heats the part that is to be continually immersed. The cable is covered with a Teflon® coating. This plastic sheath enables the heaters to resist the flow of heat and the chemical attack of the bath.

(1) heating part, to be kept immersed
(2) non heating part N, standard length 1m
(3) connection, IP64
(4) electrical cable C, standard length 1m

Specifications

The heating part comes in the form of a flat or cylindrical unit. It is followed by a non-heating-support-stem (called N) which must be covered by at least 20 cms of liquid.

The two black marks on the N part indicate the minimum and the maximum level of solution. The connection must be installed out of the tank and out of vapours.

The N part can be flexible or rigid and lengthened. It is protected by an expandable PP braided sleeving. After the N part there is a tube called «connection» in which we link our cable to a standard electric cable of type HO5 VV-F or HO7 RN-F according voltage and power (C part).

Connection

All necessary information regarding the heater is engraved on its moisture proof connection : reference number, serial number, power and voltage. The connection is IP64 and is injected with PVC. Dimensions : single-phase Ø 30 mm, L=195 mm, three-phases Ø 40 mm, L=220 mm